Long term use of vacuum enema may result in some malfunctions. In fact, many malfunctions are caused by improper operation of the staff, but there are also many reasons, as the machine will run slowly over time, unable to fully cut the product, and will vacuum. The reasons include low temperature, meat sedimentation, etc. How can we address these reasons? Let's analyze how to deal with common malfunctions of vacuum enema machines.
Analysis and Handling of Five Common Malfunctions in Vacuum Enema Machines
Fault 1: The drive motor of the sausage filler is not working. Solution: Actually, many friends know that this is because the power supply is not connected correctly. Is it true? Of course, this is just one of the reasons. Another reason is that the fuse is blown, and only one fuse needs to be replaced.
Fault 2: Insufficient cylinder pressure in the auxiliary machine of the enema machine. Solution: This is mainly due to the low pressure regulation on the pressure regulator of the enema mechanical cylinder. You only need to increase the working pressure of the pressure regulator on the cylinder.
Fault 3: The spiral feeding transmission device of the sausage filling machine is not flexible. Solution: This is mainly due to the lack of lubrication in the screw feed transmission device. You only need to purchase some lubricant to lubricate the spiral feed transmission device.
Fault 4: The enema machine cannot complete the filling function
Solution:
Reason 1: The vacuum tube in the sausage filler may be blocked by meat. You only need to remove the vacuum tube from the machine and clean it.
Reason 2: It may be due to a clogged vacuum pump filter, which has been cleaned or replaced.
Reason 3: It may be that the reverse arm was not installed in the thick material being filled. Check if the reversing arm is installed in the machine. If the reversing arm is not installed, please install it in a timely manner.
Reason 4: The scraper may not have been installed. Some friends may have forgotten to hastily install the scraper. At this point, please check if the scraper is installed in the machine. If not, please install it promptly.
Reason 5: It may be because the meat is too cold or too hard. If there is a mechanical switch button, the temperature can be adjusted. Please remember to keep the temperature above -5 ℃. If you don't have a mechanical switch button, just adjust the meat quality. Put it in the refrigerator, adjust the temperature to 0-3 degrees, take out the finished product after 10 minutes, and remember to soften the meat.
Reason 6: It may be due to incorrect insertion of pump blades. Attempt to align the grooves of the pump blades with the center of the rotor.
Reason 7: It may be due to insufficient lubrication of the pump. At this point, please try to lubricate the entire pump.
Fault 5: The pump of the vacuum enema machine has not stopped. Solution: This is mainly because the weighing knob may be located between two adjustment positions. Try positioning the weighing adjustment knob to locate the pin.
The above are some common malfunctions of vacuum enema machines. When using an enema machine, it is necessary to maintain the equipment correctly. No matter how good the machine is, its lifespan will still be shortened.
